Status
Edit
Loops
Graph
Info
Pump
Menu
7.10.4 Creating or modifying a program (Edit)
Here, there are the following functions:
Entry of a program.
Display of the program data of a saved program and modification of the segment data.
Insertion or appending of a new segment.
Deletion of a segment.
Entering a program:
64 / 123
Continue
Stop
End
Prog.1 Standby
In addition, when a program has just been executed, new segments can be inserted and existing
ones modified, even the currently active segment. Furthermore, all segments, except the cur-
rently active one, can be deleted at any time.
Modifications to the currently running segment are possible. The segment then continues as
though the modification had been applicable since the start of the segment.
However:
If the new segment time is shorter than the segment time that has already
run, then the program skips to the next segment.
If a segment time >999h:59min is required, then this time period must be shared over a number
of consecutive segments.
Proline heating thermostat
In addition, the standby key
After pressing the standby key
Program example ( 7.10.1).
grammer! Pump and heater are switched off.
Follow the safety information ( 7.7.3).
programmer returns to the previously selected
operating mode:
Pause or active operation depending on what
was previously selected.
stops the pro-
again, the
02/2022