Restoring Works Settings - Lauda PROLINE Edition X P 5 C Operating Instructions Manual

Proline Edition X heating thermostats

7.8.5 Restoring works settings

Master
3x to
PArA
to
dEF
3 seconds long
Command
All modules
Master
Command
Pump Menu
YACE0099 / 10/9/2018
dEF
If you would like to restore all the works settings except the control pa-
rameters
 call the works settings
MNEnu
3x

°C
 Press longer than 3 seconds.
 The changeover is acknowledged with
or  Proceed to the next menu until
 Press this key.
All default
only control par int
only control par ext
only miscellaneous
End T
P1d
and the probe calibrations
dEF
is displayed.
T
set fix
Starting up
CAL
dEF
.
donE
End
appears.
Works setting
 Open the device parameter menu via
the soft key Menu .
 With the cursor keys continue to:
 
Settings Works settings
 The window shown opposite appears.

Master and then
is shown as a possible choice.
There are however various possibilities,
which can be selected with
 Under
All modules
and all connected modules are reset to
the works setting with
,
.
.
only control para int
or :
Master, Command
All default .
51