Table of Contents
Advertisement
7.7
Important settings
7.7.1 Temperature setpoint setting
The setpoint is the temperature which the thermostat should reach and maintain constant.
Master (main level)
or
Wait 4 seconds or
Command
Enter new setpoint:
Min: -40,00°C Max:202,00°C
1
Help
6
Menu
38 / 123
SEt
Press key until
Press, display flashes.
Enter the setpoint with the two keys ( Section 7.4.1 General key func-
tions and pilot lamps).
Display flashes 4 s new value is automatically accepted, or
value is accepted immediately with Enter key.
For safety reasons the setpoint can only be set up to 2 °C above upper limit
of the operating temperature range for the relevant device type.
In the following cases the manual setpoint entry is blocked:
Setpoint is taken from the analog module, from the programmer in the
Command remote control or via the serial interface.
123,
45
2
3
4
7
Screen
8
T
9
set
Proline heating thermostat
SEt
(Setpoint) appears.
T
or T
set
or the soft key
point window.
123.45 is the setpoint which is still active.
The upper and lower limit temperatures are dis-
played (device-specific values).
There are three different possible entry methods:
1. Change the value with the
you vary the 1/10 °C values. If you hold the
key pressed longer, then full degrees change.
2. Enter the complete number with the numerical
5
duo keys and the
T
0
fix
and decimal point.
3. Using
to the decimal place which you would like to
change and then change it with
fix
T
opens the set-
set
or
key for the negative sign
or
, move the flashing cursor line
02/2022
keys. First
or
.
Advertisement
Table of Contents
