Setpoint Offset Operating Mode - Lauda PROLINE P 5 C Operating Instructions Manual

Lower limit (Til)
Min: -50,0 °C
1
Help 6 Menu

7.8.4 Setpoint offset operating mode

With this function it is possible to apply an offset value to the temperature provided by the external temperature probe
or a module and then to use it as the setpoint. The bath temperature can, for example, be operated at -25 °C below
the temperature of a reactor, which is being measured by the external temperature probe.
Master
3x to
MNEnu
to 5x
PArA
SEtq.
r 0FF
Wait 4 seconds or
r0FFS
Wait 4 seconds or
02/2022
-50,
0
Max: 301,0 °C
2 3 4
7 Screen 8 T 9
set
SEtq.
SEtq.

source of the actual value can be entered.
 Continue with
°C
 The offset operating mode is currently deactivated.
 To activate it press
°C
(external via analog module) or
 Display flashes 4 s  new value is automatically accepted, or
 value is immediately accepted with the Enter key.
 Continue with
°C
 To activate the relative offset input press
or
 Display flashes 4 s  new value is automatically accepted, or
 value is immediately accepted with the Enter key.
Proline heating thermostat
 Enter the desired limit temperature.
 Accept the change with
 or quit the window with
changes.
5
T 0
fix
in the following submenu the relative setpoint (Set) and the
.
and with
. The left-hand window is displayed.
.
,
without making
EP
change to (external Pt100),
ES
(external via serial module).
and change the value with
EA
49 / 123