Operation - MICRO-EPSILON induSENSOR DTD Operating Instructions Manual

Operation

5.
i
i
The parameter setup of the controller may either be performed via keys on the controller or via the sensor-
TOOL, see A
Only with the induSENSOR DTD
With the induSENSOR DTD, everything is set at the factory. There are no operation elements. Settings can
only be made via the sensorTOOL program.
induSENSOR DTD / MSC7xxx
Operation
Before starting the measurement or making settings, let the controller with connected sensor warm up
for approx. 2 minutes while supply voltage is switched on.
Observe the operating instructions of the sensors used.
If a sensor is replaced, the channel must be re-parameterized and readjusted.
3. The output is then via the analog outputs or the RS485 interface, see A 4 or the sensorTOOL.
Page 45