MICRO-EPSILON induSENSOR DTD Operating Instructions Manual page 13

Functional Principle, Technical Data
Modell
Shock (DIN-EN 60068-2-27)
Vibration (DIN-EN 60068-2-6)
Protection class (DIN-EN 60529)
Material
Weight
Compatibility
No. of measurement channels
Power supply protection
Sensor excitation
7
Gain
Zero
EMC
FSO = Full scale Output
1) Noise: AC RMS measurement via RC low-pass filter of the 1st order with f
2) V = 5 V: no voltage output available; current output: max. load 100 Ω; V
+
output: max. load 250 Ω
3) Sensor side
4) Connection via interface module, optional
5) With controllers including a current output, the output signal is limited to approx. 21 mA.
6) Mounting clamp included in
7) Adjustable via buttons; via software, additional steps can be adjusted under frequency.
induSENSOR DTD / MSC7xxx
DTD
40 g / 6 ms in 3 axes, 2 directions and 1000 shocks each
100 g / 5 ms in 3 axes, 2 directions and 9 shocks each
±1.5 mm / 5 ... 57 Hz in 3 axes, 10 cycles each
±20 g / 57 ... 500 Hz in 3 axes, 10 cycles each
Stainless steel
approx. 50 g
Full-bridge sensor/
LVDT (DTA series)
1
Preset at factory,
cannot be changed
Determination by 2 points of a straight line of the output signal with respect to the target position.
The distance between the two points must be greater than 10 % of the measuring range.
Adjustable via buttons (MSC series) and software (all series)
accessories, see A 1
delivery, see 3.1
MSC7401
IP67 (plugged)
Aluminum die casting
approx. 200 g
Full-bridge sensor/LVDT (DTA series) and half-bridge sensor (LDR series)
1
Reverse polarity protection, overvoltage protection
-550 mV , 350 mV
PP
1, 2, 5, 10, 13 kHz (DTA) / 9, 13, 16, 21, 23 kHz (LDR)
DIN EN 61326-1; DIN EN 61326-2-3
= 5 kHz
c
= 9 V: voltage output: 0.5 V ... 4.5 V or 0 V ... 5 V; current
+
MSC7802
5 g / 6 ms in 6 axes,
1000 shocks each
15 g / 11 ms in 6 axes,
±2 mm / 10 ... 15.77 Hz
in 3 axes, 10 cycles each
±2 g / 15.77 ... 2000 Hz
3 axes, 10 cycles each
approx. 280 g approx. 120 g
2
, 150 mV , 75 mV
PP PP PP
MSC7602
10 shocks
IP20
Polyamide
2
Page 13