MICRO-EPSILON induSENSOR DTD Operating Instructions Manual page 35

Installation and Assembly
Wiring
The housing must be
see
Secondary +
Secondary -
Secondary
center tap
Primary -
Primary +
Sensor cable
shield
Fig. 27 Pin assignment for the sensor at terminal block X2, full bridge
Terminal block X2
Shield (sensor cable)
Secondary center tap
Secondary +
Secondary -
Primary +
Primary -
Fig. 28 Table of the pin assignment for the sensor at terminal block X2, full bridge
1) The colors and pins listed refer to the sensors from MICRO-EPSILON MESSTECHNIK GmbH & Co. KG.
induSENSOR DTD / MSC7xxx
open, see
4.5.1.
Loosen the screws.
Pass the sensor and signal cables through the cable glands.
Connect the cables to the terminals according to the pin assignments.
Magnetic core
Pin
1
2
3
4
5
6
4.5.3, to connect the sensors and wire the output and power supply
Plunger
Cable Braid
1 1
DTA-x-CA-x DTA-x-LA-x
DTA-x-CR-x
C701-x
Shield -
Gray Gray
White White
Brown Black
Green Green
Yellow Yellow
Solder pin Cable
1 1
DTA-x-TA-x DTA-xG8-x
- Shield
5 Gray
1 Black
2 White
3 Blue
4 Brown
cable,
Page 35