Synchronization And Installation Of Multiple Channels - MICRO-EPSILON induSENSOR DTD Operating Instructions Manual

Operation
5.5.2
MSC7602 model
If the minimum distance of ≥ 100
possibility to synchronize the supply frequency of the sensors. This significantly reduces or eliminates cross-
talking between the channels, which strongly depends on the sensor used and the distance or arrangement
to one another.
The following prerequisites/restrictions apply for sync operation:
- All synchronized sensors must be operable with the supply frequency of the master
- In sync mode, no automatic sensor recognition is possible with the slave.
- In sync mode, the slave channel must be set to the frequency of the master.
- The synchronization settings are not possible via the
- Synchronization is only possible with a frequency response set to ≥ 50 Hz.
The respective synchronization modes can be set via DIP switches:
Fig. 65 DIP switch on the induSENSOR MSC7602 for synchronization
1) Factory settings
induSENSOR DTD / MSC7xxx

Synchronization and Installation of Multiple Channels

mm, see
Switch setting
S1
off
1
off
on
on
5.3, is impossible, the MSC7602 model in addition offers the
sensorTOOL, see A
Operation
S2 Sensor 1 Sensor 2
off independent independent
1
on Master
off Slave independent
on Slave
sensor, see
3.
Slave
Slave
5.3.3.
Page 65