Daikin VRV III Manual page 94

ED34-862
Swing flap motor lead wire
<Wiring Diagram>
(The orientation of the indoor unit is changed
for purposes of description.)
Fig. 9
4. INSTALLATION OF SUCTION GRILLE AND SERVICE COVER
(1) Install the suction grille
Install by reversing the procedure shown in "PREPARATION OF DECORATION PANEL".
It is possible to install the suction grille in 4 directions by turning the suction grille.
Change the direction when adjusting the direction of the suction grille of multiple units or in meeting
customers' demands.
Install the suction grill.
Tilt the suction grill at a
1
45˚ angle and fix 3 hooks
to the decoration panel.
Decoration
panel body
Suction grill
NOTE :
Be careful not to get swing flap motor lead wire get caught when installing the suction grille.
FXFQ-P
Hook up the strings of the suction grill to the fixtures of the
2
body corners (2 places) as shown below.
NOTE:
String
When mounting the
suction grill, strings may
be caught in the grill.
Be sure that
strings do not
Suction grill
hang out of the
suction grill edges.
String Fixture
String
7 Swing flap motor lead wire
Decoration panel side
Screw
(2 locations)
Loosen the two screws, slide the cover
in the direction of the arrows,
and disengage from the hooks.
Slowly push the suction
3
grill up and lastly, ensure
the grill is fastened to the
decoration panel body,
keeping pressing 2 knobs.
It should not
hang outside.
Fixture
String
When installing the grill,
change the direction of
the strings.
Suction grill
: http://splitoff.ru/tehn-doc.html
Accessories
Connector
Connect securely
Indoor unit side
Hooks
6 8 Electric
components box lid
89
2