Daikin VRV III Manual page 91

Accessories
BYCP125K-W1 Decoration Panel
—
1. BEFORE INSTALLATION
1. PRECAUTIONS
• Refer also to the installation manual attached to the indoor unit.
2. ACCESSORIES
• Installation manual.
3. NOTE TO INSTALLER
• Be sure to instruct the customer how to properly operate the system showing him/her the attached
operation manual.
2. PREPARATION OF DECORATION PANEL
<<For this unit, you are able to select air flow directions. To discharge air in 2 or 3 directions, it is necessary
to purchase optional blocking pad kit.>>
HANDLING OF DECORATION PANELS
• Never place the panel facing down nor lean it against a wall nor leave it on a projecting object.
• Never touch or put pressure on the swing flap.
(The swing flap may malfunction)
(1) Remove the suction grille from the decoration panel.
1 Press the lever on the suction grille and lift the lever side. (Refer to Fig. 1)
2 Detach the suction grille from the decoration panel by lifting the grille up approximately 45 degrees.
(Refer to Fig. 2)
3 Remove the transporting cardboard (in 4 locations) from the main unit. (Refer to Fig. 3)
4 Remove the transporting tape (in 4 locations) on the back of the suction grille. (Refer to Fig. 4)
Corner section
decoration cover
Suction grille
Lever
(2) Remove the corner section decoration cover.
• Lift the four corner decoration covers in the direction of the arrow and remove. (Refer to Fig. 5)
Cardboard
Fig. 3
86
Decoration
panel
Swing flaps
Fig. 1
Rear side of the suction grille
Fig. 4
O
45
Fig. 2
Corner section
Tape
decoration cover
Suction grille
Fig. 5
: http://splitoff.ru/tehn-doc.html
ED34-862
FXFQ-P