Daikin VRV III Manual page 114

ED34-862
Installation of Indoor Unit Main Body and Ultra-Long Life Filter Unit
• Install the indoor unit main body and ultra-long life filter unit.
At the time of installation, perform engineering work according to the installation manual
attached to the air conditioner's main body. (For the installation height, refer to the figure to
the right.)
• When mounting the ultra-long life filter unit to the existing indoor unit main body, change the
installation height of the indoor unit main body to height
• Mount the supplied installation pattern paper to the indoor unit by using screws
to cure the indoor unit.
(Refer to the installation manual of the indoor unit main body.)
(Refer to the figure below.)
[Mounting of installation pattern paper]
• Complete all the refrigerant and drain piping work for the indoor unit main body.
Mounting of Decoration Panel and Mounting of Ultra-Long Life Filter
• After temporarily hooking the decoration panel, pass the swing motor lead wire, which is coming out from the decoration panel, through the wire through hole of the ultra-long
life filter unit.
• Mount the decoration panel according to the installation manual attached to the decoration panel.
• Mounting of ultra-long life filter
After the completion of wiring and sticking of sealing pad (2 positions), mount the
ultra-long life filter. Figure 6
With wireless unit
• Route the connector of the receiver lead wire through the wire through hole, then connect the connector on the indoor printed circuit board assembly.
• For details on the connection method, refer to the installation manual attached to the wireless remote control kit (sold separately).
Preparation of Indoor Unit
• With the mounting of a ultra-long life filter unit, setting the indoor unit main
body is required.
Using the field setting mode on the remote control, switch to the setting
position number shown in the table to the right.
For the field setting mode, refer to "How to perform field setting" attached
to the remote control.
FXFQ-P
in the figure to the right.
Installation pattern paper
(Supplied with indoor unit main body)
M4 × 12 Screw
(Supplied with indoor unit main body)
Ultra-long life filter chamber
Wire through hole
Swing motor lead wire:
Route from the panel side to the
ultra-long life filter chamber.
(After temporarily hooking the
decoration panel, pass through
the wire through hole.)
Decoration panel
Figure 7
Indoor unit
main body
Ultra-long life filter unit
BYCP125K-W1
Sealing pad (supplied): For preventing air bypass
Figure 6 (Stick to 2 positions in the same manner.)
Decoration panel
Ultra-long life filter unit
Rotate the filter clasp by 90˚
to fix the filter.
(4 positions)
Figure 7
Mode number Setting switch number Setting position Number
Where there is minimal fouling
(Example: Office, etc.)
0
10 or 20
Where there i s consi d erabl e foul i n g
(Exampl e : Pachi n ko parl o r, etc.)
1
: http://splitoff.ru/tehn-doc.html
Accessories
Suspension bracket
(Installation height
guideline)
Ceiling surface
(mm)
180
Filter clasp
Ultra-long life filter
Filter sign display interval time
01 Approximately every 10,000 hours
02 Approximately every 5,000 hours
02 Initial setting for ultra-long life filter
JC : 3K015221D
2
109