Advertisement
Installation
2.1.7 Cable Stress
2.1.6 Handling Oil and Water
2
2.1.7 Cable Stress
TERMS
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Install a protective cover over the Servomotor if it is used in a location that is subject to water
or oil mist. Also use a Servomotor with an oil seal to seal the through shaft section.
Install the Servomotor with the connector facing down.
Through shaft section
Make sure there are no bends or tension on the power lines.
Be especially careful to wire signal line cables so that they are not subject to stress because the
core wires are very thin at only 0.2 to 0.3 mm (0.0079 to 0.012 in).
z Through sections of the shaft
This refers to the gap where the shaft protrudes from the end of the motor.
2 -6
Advertisement
