Advertisement
Using the Digital Operator
7.1.6 Operation in User Constant Setting Mode
7.1.6 Operation in User Constant Setting Mode
7
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Functions can be selected or adjusted by setting user constants. There are two types of user
constants. One type requires value setting and the other requires function selection. These two
types use different setting methods.
With value setting, a user constant is set to a value within the specified range of the user constant.
With function selection, the functions allocated to each digit of the seven-segment LED panel
indicator (five digits) can be selected. Refer to Appendix B List of User Constants.
J J Changing Constant Settings
The constant settings can be used for changing constant data. Check the permitted range of the
constants in Appendix LEERER MERKER List of User Constants, before changing the data. The
example below shows how to change user constant Pn507 from 100 to 85.
Using the Hand-held Digital Operator
1. Press DSPL/SET Key to select the user constant setting mode.
2. Select the user constant number to set. (Pn507 is selected in this example.)
Press the Left or Right Cursor Key to select the digit. The selected digit will flash.
Press the Up or Down Cursor Key to change the value.
3. Press the DATA/ENTER Key to display the current data for the user constant selected at step
2.
4. Change to the required data.
Press the Left or Right Cursor Key to select the digit. The selected digit will flash.
Press the Up or Down Cursor Key to change the value. Continue pressing the key until
"00085" is displayed.
5. Press the DATA/ENTER Key to store the data. The display will flash.
6. Press the DATA/ENTER Key again to return to the user constant number display.
This procedure has changed the setting of the user constant Pn507 from 100 to 85. Repeat
steps 2. to 6. as often as required.
7 -8
Advertisement
