Table of Contents
Advertisement
♦ Press the selected program key (19) repeatedly until the drying time
appears in the cycle display (Figure 19).
Cycle
Drying Time
15 min
Figure 19: Display drying time
♦ Increase the drying time using the ▲ key (16).
The drying time will increase in one-minute increments with each press of
the ▲ key (16).
10.2 Adjusting the removal pressure
♦ Press the program key P1 several times until the removal pressure
appears in the cycle display (Fig. 20).
Figure 20: Removal pressure display
♦ Use the ▲- ▼-keys to set a value of 10-15kPa above the average
ambient pressure.
♦ Repeat the setting on the program keys P2 and P3.
10.3 Setting date, time and timer
To use the timer or the timer for batch documentation (integrated printer option),
you must first set the current date and time:
Time and date
♦ Press and hold the Timer key (24).
♦ Press the START/STOP key (20).
♦ Release both keys (24, 20).
The cycle display (18) now shows the date for the timer. Use the ▲ key (16)
and the ▼ key (17) to display the timer settings, the current time and the
durrent date.
To change the settings for day / month / year or hours / minutes, press the
program key below, and change the value using the ▲ key (16) or the ▼ key
(17).
Thermo Scientific
10 Settings
59
50112712_082007_GB
Advertisement
Table of Contents
