Table 60: Device-Specific Parameters - WAGO 750 XTR Manual

WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR
The 750-333/040-000 fieldbus couplers allow channel pair granular
parameterization of the diagnostics as well as further module and channel or
channel pair specific settings. The following assignment applies to the
parameters of the I/O module, also in connection with the use of WAGO-I/O-
CHECK or e!COCKPIT.

Table 60: Device-Specific Parameters

GSD File
Description
I/O-module is
physically
Watchdog timer
[I/O module]
Diagnosis
[Channel pair x
(x = 0,1)]
Bridge mode
[Channel pair x
(x = 1, 2)]
Load between
output and
[Channel x
(x = 0, 1, 2, 3)]
Operating mode
[Channel x
(x = 0, 1, 2, 3)]
Operating mode
[Channel x
(x = 0, 2)]
Factory default
*)
Value
plugged *)
(optional) not plug fitted
deactivated
activated *)
disabled
*)
enabled
deactivated *)
activated
Uout− to CC 2 or CC6
*)
Uout+ to CC 3 or CC7
PWM DC *)
PWM Frq
PWM Frq-Cnt
Pulse Frq-Cnt
PWM Pulse-Dir
Commissioning
WAGO-I/O-CHECK and e!COCKPIT
Selection Box Value
- -
-
Watchdog timer Checkbox disabled
[General]
Checkbox enabled
- -
-
Bridge mode Checkbox disabled
[Channel x
Checkbox enabled
(x = 1 & 2, 3 & 4)]
Load between output Uout−
and
[Channel x
Uout+
(x = 1 & 2, 3 & 4)]
Operating mode PWM DC
[Channel x
PWM Frq
(x = 1 & 2, 3 & 4)]
PWM Frq-Cnt
Pulse Frq-Cnt
PWM Pulse-Dir
87
*)
*)
*)
Manual
Version 1.0.0