Connection Examples; Figure 13: Connection Example 1 - WAGO 750 XTR Manual

68 Connect Devices
7.2

Connection Examples

Use shielded signal lines!
Only use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then can you ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
Reference potential for loads
The terminals Uout- or Uout+ (see connection examples) must be used as
reference potential for the loads, as otherwise internal protection and filter
functions are disabled.
Example 1: 2 channels are configured with inverted output ("load between output
and Uout+"), 2 channels are configured with non-inverted output ("load between
output and Uout−"). The loads are connected accordingly against Uout+,
respectively against Uout−.

Figure 13: Connection Example 1

Manual
Version 1.0.0
WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR