Parameter Settings; Table 45: Status Byte 2 (Pulse Frq-Cnt); Table 62: Status Byte 0 - WAGO 750 XTR Manual

56 Operating Modes
Table 44: Status Byte 0 (Pulse Frq-Cnt)
Bit 7
Reg General Error
Com
Legend
RegCom

Table 45: Status Byte 2 (Pulse Frq-Cnt)

Bit 7
Reg General Error
Com
Legend
Enable DO 3 & DO 4
Drivers
PWM enabled
Status of output DO 4
Short circuit DO 3 or
DO 4
Undervoltage
General Error Bit
RegCom
Status byte 1 and 3 are permanently "0".
Frequency Level Depends on Duty Cycle
The frequency preset can only be taken into account to the extent that leads to a
duty cycle of max. 100%.
4.4.2

Parameter Settings

The pulse duration can be preset in the range from 1 ... 1,000,000 µs.
The set value is non-volatile and is retained after a restart.
Manual
Version 1.0.0
Bit 6 Bit 5
Undervoltage
Bit
0: Register communication is disabled (normal mode).
1: Register communication is enabled.
Bit 6 Bit 5
Undervoltage
Bit
0: The status of the output driver for DO 3 & DO 4 is disabled.
1: The status of the output driver for DO 3 & DO 4 is enabled.
0: No output of a PWM signal is enabled.
1: The PWM output is enabled.
0: The output DO 4 is disabled.
1: The output DO 4 is enabled.
0: There is no short circuit at outputs DO 3 or DO 4.
1: There is a short circuit at output DO 3 or DO 4.
0: There is no undervoltage on the I/O module.
1: There is an undervoltage on the I/O module.
0: There is no error.
1: There is an undervoltage or a short circuit.
Bits 0-3 are masked out.
0: Register communication is disabled (normal mode).
1: Register communication is enabled.
WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR
Status byte 0
Bit 4 Bit 3 Bit 2
Short circuit Status of
DO 1 or output
DO 2 DO 2
Status byte 2
Bit 4 Bit 3 Bit 2
Short circuit Status of
DO 3 or output
DO 4 DO 4
Bit 1 Bit 0
Enable DO 1
PWM
- &
enabled
DO 2 Drivers
Bit 1 Bit 0
Enable DO 3
PWM
- &
enabled
DO 4 Drivers