WAGO 750 XTR Manual page 78

78 Commissioning
Table 57: 750-677, "Channel X & Y" Menu Item
Parameter
Load between
output and
*) Factory default
**) Adjustable only for channel 1 and channel 3
1) Operating mode PWM DC
2) Operating mode PWM Frq
Operating mode PWM Frq-Cnt
3)
4) Operating mode Pulse Frq-Cnt
5) Operating mode PWM Pulse-Dir
The following examples explain a selection of possible settings.
Example 1: In this example, two different operating modes are set for the first
channel pair (channels 1 & 2). The setting options for other parameters are
correspondingly different.
Figure 24: 750-677, "Channels X & Y" Menu Item, Selecting the Operating Mode (Example 1)
Manual
Version 1.0.0
750-677/040-000 4PWM 24 VDC 0.2A XTR
Setting Option / Description
Compensation option for different reference potentials.
Note: After an output has been released (see Section
"Data Dialog"), it is always connected to one of the two
reference potentials, depending on the switched status. It
is only highly resistive to both potentials (Tri-state) if the
release does not take place.
U − *)
out
U +
out
WAGO I/O System 750 XTR
If the option is enabled, the
output behaves like a high-side
switch, but is designed as a
push-pull.
If the option is enabled, the
output behaves like a low-side
switch, but is designed as a
push-pull.