Table 31: Control Byte 2 (Pwm Frq); Table 32: Status Byte 0 (Pwm Frq); Table 33: Status Byte 2 (Pwm Frq) - WAGO 750 XTR Manual

48 Operating Modes

Table 31: Control Byte 2 (PWM Frq)

Bit 7
RegCom
Legend
Enable DO 3 & DO 4
Drivers
RegCom
Control bytes 1 and 3 can be permanently "0" and have no influence on the
system.

Table 32: Status Byte 0 (PWM Frq)

Bit 7
Reg General Error
Com
Legend
Enable DO 1 & DO 2
Drivers
Short circuit DO 1 or
DO 2
Undervoltage
General Error Bit
RegCom

Table 33: Status Byte 2 (PWM Frq)

Bit 7
Reg General Error
Com
Legend
Enable DO 3 & DO 4
Drivers
Short circuit DO 3 or
DO 4
Undervoltage
General Error Bit
RegCom
Status byte 1 and 3 are permanently "0".
Manual
Version 1.0.0
Bit 6 Bit 5
- -
0: The output driver for DO 3 & DO 4 is disabled.
1: The output driver for DO 3 & DO 4 is enabled.
0: Register communication is switched off.
1: Register communication is switched on.
Bit 6 Bit 5
Undervoltage
Bit
0: The status of the output driver for DO 1 & DO 2 is disabled.
1: The status of the output driver for DO 1 & DO 2 is enabled.
0: There is no short circuit at outputs DO 1 or DO 2.
1: There is a short circuit at output DO 1 or DO 2.
0: There is no undervoltage on the I/O module.
1: There is an undervoltage on the I/O module.
0: There is no error.
1: There is an undervoltage or a short circuit.
Bits 0-3 are masked out.
0: Register communication is disabled (normal mode).
1: Register communication is enabled.
Bit 6 Bit 5
Undervoltage
Bit
0: The status of the output driver for DO 3 & DO 4 is disabled.
1: The status of the output driver for DO 3 & DO 4 is enabled.
0: There is no short circuit at outputs DO 3 or DO 4.
1: There is a short circuit at output DO 3 or DO 4.
0: There is no undervoltage on the I/O module.
1: There is an undervoltage on the I/O module.
0: There is no error.
1: There is an undervoltage or a short circuit.
Bits 0-3 are masked out.
0: Register communication is disabled (normal mode).
1: Register communication is enabled.
WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR
Control byte 2
Bit 4 Bit 3 Bit 2
- - -
Status byte 0
Bit 4 Bit 3
Short circuit
-
DO 1 or DO 2
Status byte 2
Bit 4 Bit 3
Short circuit
-
DO 3 or DO 4
Bit 1 Bit 0
Enable DO 3 &
-
DO 4 Drivers
Bit 2 Bit 1 Bit 0
Enable DO 1 &
- -
DO 2 Drivers
Bit 2 Bit 1 Bit 0
Enable DO 3 &
- -
DO 4 Drivers