Figure 31: Data Dialog, Example 1 - WAGO 750 XTR Manual

82 Commissioning
The data dialog is displayed in different forms, depending on the operating
modes set.
Some of these features are described below by way of example.
Example 1:
Channel 1: PWM DC
Channel 2: PWM Frq
Channel 3: PWM DC
Channel 4: PWM Frq
Figure 29: Data Dialog, Example 1
The Channel 1 and Channel 3 areas each show the control elements for the
preset operating mode PWM DC. The process data value (duty cycle) can be
entered as a value or set with the slider and changed dynamically.
The Channel 2 and Channel 4 areas each show the control elements for the
preset operating mode PWM Frq. The process data value (frequency) can be
entered as a value or set with the slider and changed dynamically.
None of the channel pairs is enabled, the outputs are therefore high-impedance
(Tri-State)
Manual
Version 1.0.0
WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR