Table 36: Control Byte 0 (Pwm Frq-Cnt); Table 37: Control Byte 2 (Pwm Frq-Cnt) - WAGO 750 XTR Manual

WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR

Table 36: Control Byte 0 (PWM Frq-Cnt)

Bit 7
RegCom
Legend
Enable DO 1 & DO 2
Drivers
Start/stop PWM
Reset counter
RegCom

Table 37: Control Byte 2 (PWM Frq-Cnt)

Bit 7
RegCom
Legend
Enable DO 3 & DO 4
Drivers
Start/stop PWM
Reset counter
RegCom
Control bytes 1 and 3 can be permanently "0" and have no influence on the
system.
Control byte 0
Bit 6 Bit 5 Bit 4
- - -
0: The output driver for DO 1 & DO 2 is disabled.
1: The output driver for DO 1 & DO 2 is enabled.
Negative edge: The PWM output at DO 1 is stopped.
Positive edge: The PWM output at DO 1 is started.
Positive edge: The count value is reset.
0: Register communication is switched off.
1: Register communication is switched on.
Control byte 2
Bit 6 Bit 5 Bit 4
- - -
0: The output driver for DO 3 & DO 4 is disabled.
1: The output driver for DO 3 & DO 4 is enabled.
Negative edge: The PWM output at DO 3 is stopped.
Positive edge: The PWM output at DO 3 is started.
Positive edge: The count value is reset.
0: Register communication is switched off.
1: Register communication is switched on.
Operating Modes
Bit 3 Bit 2 Bit 1
Start/stop
Reset
- PWM
counter
Bit 3 Bit 2 Bit 1
Start/stop
Reset
- PWM
counter
51
Bit 0
Enable DO 1 &
DO 2 Drivers
Bit 0
Enable DO 3 &
DO 4 Drivers
Manual
Version 1.0.0