Tube Ref No.
Lubriplate SPO 255
136
11. Install the valve stem keepers.
12. Confirm that the valve stem keepers are properly seated in the grooves of the valve stem.
a
13. Slowly release the valve spring compressor.
14. Set the assembly by tapping the valve stem with a soft plastic hammer.
15. Check the installed height of the valve springs using a narrow, thin scale. Measure from the spring seat to the top of the
valve spring.
IMPORTANT: To ensure correct measurement, measure the spring height from the top of the valve spring, not the top of
the valve.
IMPORTANT: If measurement exceeds specified height, install a valve spring shim and recheck. Do not shim valve springs
to give an installed height less than the minimum specified.
Description
Valve spring installed height
a
Installation
1.
Ensure that the engine block and cylinder head sealing surfaces are clean.
90-8M0099748 eng DECEMBER 2015
Description
Exhaust
Where Used
Valve stem keepers
b
c
d
Intake
© 2016 Mercury Marine
Engine Inspection and Assembly
Obtain Locally
a -
Valve spring
compressor
b -
Valve stem keepers
c -
Retainer
d -
Valve spring
33025
6.2 Liter (377 cid)
46.19 mm (1.818 in.) minimum
Typical
a -
Cut away scale
b -
Valve spring installed
height
b
19503
Part No.
Page 3B-51