29. Verify the wires will not become pinched and install the upper housing.
30. Carefully push the upper housing into the lower housing until there is no gap between the upper and lower housing.
IMPORTANT: If the gap between the upper and lower housing cannot be closed, the wires may be pinched or a seal
grommet is not properly aligned.
31. Install the screws and tighten the screws to the specified torque.
a
Description
Screw
32. Install a 16.2 mm metal hose clamp onto the high‑pressure hose and install the hose onto the FSM upper housing. Use the
hose clamp tool to secure the hose to the FSM.
90-8M0099748 eng DECEMBER 2015
a -
No gap
b -
Screw (4)
b
49240
© 2016 Mercury Marine
MPI ECT Fuel System
49237
Nm
lb‑in.
10
88.5
57375
lb‑ft
Page 5A-21