Power-Assisted Steering Pump Pulley-Installation - Mercury MerCruiser Service Manual

4. Install the pulley removal tool on the end of the power‑assisted steering pulley and the shaft.
a
Power‑Assisted Steering Pump Pulley
Remover
5. While holding the pulley removal tool with a suitable wrench, turn the threaded bolt until the power‑assisted steering pump
pulley is removed.
Power‑Assisted Steering Pump Pulley—Installation
Install the power‑assisted steering pump pulley using the pulley install tool.
Pulley Pusher Installer
1. Lubricate the power‑assisted steering pump shaft with Power Trim and Steering Fluid.
Tube Ref No.
Power Trim and Steering
114
Fluid
2. Start the pulley on the steering pump shaft.
a
c c
b b
a a
a. Thread the stud from the pulley pusher completely into the power‑assisted steering pump shaft.
b. Place the spacer on the pulley.
c. Place the spacer and the bearing over the pulley pusher stud so that the spacer is against the pulley.
90-8M0099748 eng DECEMBER 2015
56909
Description
56910
d d
a - Pulley pusher stud
e e
b - Pulley pusher spacer
c - Pulley pusher bearing
d - Pulley pusher nut
e - Pulley pusher shaft
f - Power‑assisted steering pump pulley
f f
57120 57120
Power-Assisted Steering Pump and Related Components
a - Typical pulley removal tool
Obtain locally
91‑ 93656A 1
Where Used
Power-assisted steering pump shaft
a - Installer
© 2016 Mercury Marine
Part No.
92-858074K01
Page 8A-13