Power-Assisted Steering Hoses; High-Pressure Hose (Pump To Control Valve) - Mercury MerCruiser Service Manual

Power-Assisted Steering Pump and Related Components
Filling
1. Remove the fill cap/dipstick and observe the level.
2. Add the specified fluid to bring the fluid level up to the proper level.
Tube Ref No.
Power Trim and Steering
114
Fluid
Dexron III
28
3. Install the fill cap/dipstick.
Changing
Power steering fluid does not require changing unless it becomes contaminated with water or debris. Contact your authorized
Mercury MerCruiser dealer.
Power‑Assisted Steering Hoses
IMPORTANT: Make the hydraulic connections as quickly as possible to prevent fluid from leaking.
IMPORTANT: Do not cross‑thread or overtighten the hose fittings.
High‑Pressure Hose (Pump to Control Valve)
Removal
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
NOTE: Catch the fluid that drains from the pump and the hoses in a suitable container.
1. Note the position and the routing of the steering pressure hose before removal.
2. Remove the high‑pressure hose and the O‑ring from the power‑assisted steering pump assembly.
a
Page 8A-18
Description
© 2016 Mercury Marine
Where Used
Power steering system
Power steering system
NOTICE
a - High‑pressure hose (O‑ring not shown)
56932
92-858074K01
Obtain Locally
90-8M0099748 eng DECEMBER 2015
Part No.