Instrumentation and Controls
14‑Pin Engine Harness Connector
Pin
A
Red/black
B
Black
C
Purple
D
Black/yellow
E
Blue/yellow
F
White
G
Blue
H
Blue/black
J
Green/black
K
Orange/green
L
Tan/Lt blue
M
Gray
N
Yellow/red
P
Brown
Axius Helm Installation (if Equipped)
If installing Axius, turn to Section 1 in the Axius Installation Manual and complete the appropriate procedures. Return here
when finished and complete any other appropriate procedures in this section.
DTS Information and Installation
Special Tools ‑ DTS Installation
Data Cable Puller
Configuring the PCM Using the CDS
The computer diagnostic system (CDS) can communicate with the DTS command module. However, the CDS will not
communicate with the PCM112 controller at this time. Refer to the following information when configuring the vessel or the
engine using the CDS tool.
Configuring the PCM
The computer diagnostic system (CDS) will not configure the following, which require communication through the propulsion
control module:
•
Trailer and trim limit
•
Engine location
•
AutoSync‑Enable/Disable
•
Use CDS G3 for configuring above
Configuring the DTS Command Module
The CDS G3 can configure the DTS command module. Refer to the appropriate procedures to configure the following:
•
Vessel configuration
•
Handle adaptation
•
CAN‑based trackpad locations
Installation Guidelines for DTS System Components
Splicing or probing will damage the wire insulation allowing water to enter the wiring. Water intrusion may lead to wiring
failure and loss of throttle and shift control. To avoid the possibility of serious injury or death from loss of boat control, do not
splice or probe into any wire insulation of the DTS system.
Page 4D-26
Mechanical 14‑Pin Connector Pin‑Out
Wire Color
WARNING
!
© 2016 Mercury Marine
Clean power
Clean ground
Wake
E‑stop
Oil pressure
CAN 1+
CAN 1–
Trim up
Trim down
Trim gauge
Audio warning horn
Tachometer
Crank
Temperature gauge
91‑888462A1
90-8M0099748 eng DECEMBER 2015
Function