Seawater Hoses; Gear Lube Monitor (Sterndrive) - Mercury MerCruiser Service Manual

Seawater Hoses

Disconnect the seawater hose on all models.
a

Gear Lube Monitor (Sterndrive)

1. Disconnect the gear lube monitor from the transom.
NOTE: The quick‑disconnect shown below is located at the transom. Some models have a quick‑disconnect fitting in the
gear lube monitor hose closer to the engine. It may be more convenient to disconnect the hose at this alternate location.
a
b
2. Place the hose out of the way.
90-8M0099748 eng DECEMBER 2015
d
c
58409
a
Typical Bravo drive connection
a - Hose
b - Quick‑disconnect 90° fitting
c - Seawater inlet fitting
d - J‑clip
21623
© 2016 Mercury Marine
Removal
Typical 6.2L seawater pickup
a - Seawater inlet hose
connection
Page 2A-3