3.
Install the front mount adjustment nuts midway on the studs so that adequate up and down adjustment exists for engine
alignment.
Tube Ref No.
Loctite Silver Graphite
Anti-Seize Spray
Improper lifting during removal or installation of the engine can cause injury or damage to engine components. Use a hoist,
lifting arm, or other approved lifting device. Do not allow the lifting device to hook or compress any engine components.
4.
Attach a suitable sling, lifting corner to corner across the engine and lifting arm to the engine lifting eyes and adjust it so
that the engine is level when suspended.
IMPORTANT: Maintain a minimum 66 cm (26 in.) on each length or use a spreader bar so that no components are
damaged.
5.
Lift the engine into position in the boat using an overhead hoist.
IMPORTANT: When lowering the engine into position do not set the engine on the shift cable.
90-8M0099748 eng DECEMBER 2015
a
a -
b -
b
58233
Description
!
Front mount
Front mount stud
Adjustment nut
Where Used
Front mount studs
CAUTION
© 2016 Mercury Marine
Installation
Part No.
92-898101390
55255
Page 2B-5