Towsport Exhaust; General Information - Mercury MerCruiser Service Manual

Hide thumbs Also See for MerCruiser:
Table of Contents

Advertisement

Qty.
4
IMPORTANT: The shutter assembly must be installed no less than 10 in. after the elbow. It must be installed at a minimum
3° down angle.

TowSport Exhaust

TowSport exhaust shipped with mufflers:
Tested and qualified mufflers shipping with engine
OEM does not have to purchase separately
Internal drain

General Information

The height of the exhaust elbows must be within the dimensions specified to prevent water intrusion problems. Exhaust elbow
risers must be installed, if needed, to obtain the proper exhaust elbow height, and exhaust angle. Risers are limited to
152.4 mm (6 in.). Measurement must be taken with the boat in the water. It is important that the boat be loaded as outlined to
simulate the maximum loading conditions likely to be encountered in normal operation.
IMPORTANT: Load distribution recommendations are the responsibility of the boat manufacturer. Any load distribution
conditions that will affect the exhaust system must be clearly communicated to the operator in the owner's manual. For
example, the number of people that can be located on the swim platform simultaneously should be included in the manual, if
this could pose a problem.
Measurements under all loading conditions must be within the following specifications.
Model
6.2L TowSport
If the exhaust elbow height or exhaust angle is insufficient, modify the exhaust system or install the appropriate exhaust riser.
Refer to the appropriate Mercury Precision Parts and Accessory Guide for part numbers.
The maximum exhaust riser height is specified in the table below.
Model
6.2L TowSport
90-8M0099748 eng DECEMBER 2015
Description
Stainless steel clamps—101.60 mm (4 in.)
Minimum Exhaust Elbow Height
Model
6.2L TowSport in‑line models
6.2L TowSport V‑drive models
Minimum Exhaust Hose Slope
Low
51 mm (2 in.)
Exhaust Pipe and Through-the-Propeller Exhaust
Specification
Within 406.4 mm (16 in.) of engine
Riser Options
Medium
102 mm (4 in.)
© 2016 Mercury Marine
Part Number
Obtain Locally
Specification
33 cm (13 in.)
33 cm (13 in.)
10°
High
152 mm (6 in.)
Page 7C-7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2a456613

Table of Contents