Mercury MerCruiser Service Manual page 387

6. Lubricate the seal grommet with 2‑4‑C with PTFE and install the high‑pressure fuel pump into the lower housing so the
wires are between the webbing and the water tube.
Wires between webbing
Tube Ref No.
2-4-C with PTFE
95
7. Install the seal grommet onto the fuel lift pump and lubricate with 2‑4‑C with PTFE.
Tube Ref No.
2-4-C with PTFE
95
8. Install the fuel lift pump into the lower housing so the outlet port of the pump faces towards the center of the FSM.
9. Install the seal grommet halfway onto the outlet port of the fuel lift pump.
10. Install the seal grommet onto the high‑pressure fuel pump.
90-8M0099748 eng DECEMBER 2015
49211
Description
Description
Close up view without tube installed
Where Used
Seal grommet
Where Used
Seal grommet
© 2016 Mercury Marine
MPI ECT Fuel System
49213
Part No.
92-802859A 1
49214
Part No.
92-802859A 1
Page 5A-17