Mercury MerCruiser Service Manual page 549

Tube Ref No.
Dexron® III Automatic
28
IMPORTANT: To accurately check the fluid level, the engine must be operated at 1500 RPM for two minutes immediately
prior to checking the level.
4. Start the engine and operate at 1500 RPM for two minutes to fill all the hydraulic circuits.
5. Stop the engine and immediately check the fluid level with the dipstick resting on the top of the threaded hole.
6. If the fluid level is low, add transmission fluid to bring the level up to the maximum mark on the dipstick.
Tube Ref No.
Dexron® III Automatic
28
7. Install the dipstick.
Filling
1. If necessary, add the specified automatic transmission fluid through the dipstick threaded hole to bring the level up to the
maximum mark on the dipstick.
IMPORTANT: Use only the specified automatic transmission fluid.
Tube Ref No.
Dexron® III Automatic
28
2. Install the dipstick.
IMPORTANT: To accurately check the fluid level, the engine must be operated at 1500 RPM for two minutes immediately
prior to checking the level.
3.
Refer to Checking and check the fluid level.
Changing
IMPORTANT: Do not start or crank the engine without fluid in the transmission.
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
1. Clean the exterior of the transmission around the fluid filter assembly.
90-8M0099748 eng DECEMBER 2015
Description
Description
a -
b -
c -
d -
16604
Description
ZF/45C, 45IV, 63A, 65IV Transmissions
Where Used
Transmission
Where Used
Transmission
Dipstick
Threaded hole
Maximum fluid level
Minimum fluid level
Where Used
63A and 63IV transmissions
NOTICE
© 2016 Mercury Marine
Part No.
Obtain Locally
Part No.
Obtain Locally
Part No.
Obtain Locally
Page 9A-11