Mercury MerCruiser Service Manual page 553

b. Coat the neutral start switch and temperature switch connections with Liquid Neoprene.
Tube Ref No.
Liquid Neoprene
25
13. For DTS transmissions:
a. Connect the transmission harness to the shift solenoids and pressure transducers. Connect and route the
transmission harness as it was prior to removal.
a a
b. Connect the transmission fluid temperature switch wiring connector.
b
a
14. Check engine final alignment. Refer to Section 2B ‑ Final Engine Alignment.
IMPORTANT: All coupler bolts must be Metric Grade 10.9 (SAE Grade 8) or better, with a shoulder—grip length long
enough to pass through the face mating plane of couplers.
15. After final engine and coupler alignment has been properly set—with the boat in the water, connect the propeller shaft
coupler to the transmission output flange with bolts, lockwashers, and nuts. Tighten the bolts to the specified torque.
90-8M0099748 eng DECEMBER 2015
c
b
20096
Description
Neutral start switch and temperature switch connections
b b
a - Harness connections for "A" side shift solenoid and pressure transducer
b - Harness connections for "B" side shift solenoid and pressure transducer
39445
ZF/45C, 45IV, 63A, 65IV Transmissions
a - Fluid temperature switch
b - Neutral start switch
c - Transmission fluid cooler hose fitting
a
Where Used
a - Wire connections
b - Fluid temperature switch
50204
© 2016 Mercury Marine
Part No.
92- 25711 3
Page 9A-15