Operation Procedures; Turning Power On; Functioning Of Modules - Olympus STM7 Instructions Manual

3 3

Operation procedures

} The operation procedures are illustrated in combination with the middle manual frame as a reference. Unless otherwise
specified, the same applies to other combinations.

3-1 Turning Power ON

a
e
22
1

Functioning of Modules

CAUTION
·
1
Set the main switch b on the rear of the control box STM7-CB/STM7-
CBA to " " (ON). (Only when using the control box.)
2
Set the main switches of the modules you are using to " " (ON).
b
(For details, refer to the instruction manual provided with each
module.)
3
Confirm that the LED illuminator is turned ON by using the light
intensity control function of the hand switch STM7-HS or the focus
controller STM7-MCZ.
For details, refer to "3-3 Hand switch (Manual frame only)" (page 25) or
"3-4 Focus controller (Motorized frame only)" (page 28).
c
4
The display c on the digital indicator should be illuminated now.
Rotate the X-axis knob d , the Y-axis knob e , the fine/coarse
focusing knob f or the fine/coarse focusing knob of the focus
f
controller STM7-MCZ to make sure that the display on the digital
indicator shows counting.
d
Confirm followings before turning ON the power.
Ensure that the connection cables and the power cords
of the control box and power supply unit are connected
properly.
· When the origin search is set to ON, if the power of the
control box for motorized STM7-CBA is turned ON, be careful
the focusing unit moves upward. (Motorized frame only)
For the origin search setting, refer to page 51.
· Rotate the emergency stop switch a on the control
box for motorized STM7-CBA in the resetting direction
(clockwise) to ensure that the switch is not set to ON.
(Motorized frame only)
If the emergency stop switch is ON, refer to page 7 and
restore it.