Resetting Counter Data Of X-, Y- And Z-Axis; Outputting Counter Data Of X-, Y- And Z-Axis; Counting Counter Data Of X-, Y- And Z-Axis In-Half - Olympus STM7 Instructions Manual

a
c
d
e
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT
FULL TRACK COARSE EPI DIA
HALF SHOT FINE
g
4

Resetting counter data of X-, Y- and Z-axis

b
5

Outputting counter data of X-, Y- and Z-axis

6

Counting counter data of X-, Y- and Z-axis in-half

} The ON/OFF of the count-in-half function can be confirmed by
f
STM7-CBA
(Always displayed)
Display X of
DATA
FN
STM7-DI
(Displayed for a
specified time)
COUNT of STM7-
DI
(Always displayed)
Press the X-RESET a , Y-RESET b or Z-RESET c button to reset
the counter data of X-, Y- and Z-axis.
Press the DATA/HALF button d to output the data to the controller,
the data processing device or the printer connected to the RS-232C
connector.
When keeping the DATA/HALF button d pressed for 3 seconds or
longer, the counter data of the X-, Y- and Z-axis is displayed in 1/2
value of the actual movement distance. (The value displayed when
the button is pressed is held in memory.)
When keeping the DATA/HALF button pressed further again, the count-
in-half function is turned OFF. (The value displayed at this time is also
held in memory)
the indicator e of the control box for motorized STM7-CBA or the
display X f of the digital indicator STM7-DI or the COUNT g .
Count-in-half function: ON Count-in-half function: OFF
X
Y
Z
COUNT
Z LIMIT
FULL
HALF
X
Y
Z
AF FOCUS LED COUNT
Z LIMIT
TRACK COARSE EPI DIA FN FULL
SHOT FINE HALF
STM7
AF FOCUS LED
TRACK COARSE EPI DIA FN
SHOT FINE
31