Olympus STM7 Instructions Manual page 65

d
e
3
Mounting the stage
CAUTION
a
} When using the manual frame, rotate the coarse focusing knob a
to raise the focusing unit as much as possible before installing the
stage.
} When using the motorized frame, refer to "15 Connecting cable and
cords" (page 69) and connect cables and cords. Then, set the main
switch b of the control box for motorized STM7-CBA to " "(ON) and
rotate the coarse focusing knob c of the focusing controller STM7-
MCZ to raise the focusing unit as much as possible.
b
CAUTION
c
1
Clean the stage mounting surface of the frame.
For cleaning procedures, see "Maintenance and storage" (page 12).
CAUTION
· Keep transport rods, transport sticks, and clamps/screws
for stage transport lock in a safe place. They will be used
for next transportation.
· Sudden or severe impact may exert an adverse effect upon
the precision of the microscope. Handle the stage with
care and avoid subjecting it to sudden or severe impact.
When the focusing unit is raised, set the main switch of
the control box for motorized to " " (OFF). Unplug the
power cord from the outlet and install the stage.
· Dust on the stage may hinder the product performance to
be manifested fully.
· Remove the anti-rust sheet d and the protective film e
of the frame.
STM7
59