Olympus STM7 Instructions Manual page 69

i
g
e
h
a
b
f
Mounting the reflected light illuminator
6
(MM6C-KMAS, MM6C-RLAS)
1
Fully loosen the clamp f (stud) of the reflected light arm e using
f
the Allen screwdriver provided with the frame.
2
Fit the reflected light arm e into the mount dovetail on the frame all the
way until it is stopped. Take care that the reflected light arm is not tilted.
3
Tighten the clamp f (stud) of the reflected light arm e using the
Allen screwdriver provided with the frame.
4
Fully loosen the clamping screw h of the round dovetail g (female)
on the reflected light arm e .
5
Fit the round dovetail on the reflected light illuminator i into the
round dovetail g of the reflected light arm e so that the reflected
light illuminator faces toward the left (i.e. the fiber cable mount comes
on the left).
6
Tighten the clamping screw h of the reflected light arm e using
the Allen screwdriver provided with the frame.
7
Mounting the focus navigator unit
c d 1
Fully loosen the observation tube clamping screw a using the
Allen screwdriver provided with the frame, attach the circular mount
dovetail on the bottom of the focus navigator unit, and then tighten
the clamping screw again.
2
Insert the green LED unit (MM6-ILG) b into the LED unit installation
block c of the frame and clamp it with the clamping knob d .
8
Mounting the autofocus unit
} The autofocus unit can be mounted only on the motorized frame.
1
Fully loosen the observation tube clamping screw e using the Allen
screwdriver provided with the frame, attach the circular mount dovetail
e
on the bottom of the autofocus unit f , and then tighten the clamping
screw again.
STM7
63