Olympus STM7 Instructions Manual page 11

Intended use
This product is designed for industrial measurements to measure the length, angle or contour of inspection objects,
such as semiconductors, electronic/electric parts, precision automobile parts, resin molding, tools, etc.
Do not use this product for purposes other than described above.
Handling precautions
STM7-SF/STM7-SFA/STM7-MF/STM7-MFA
· This microscope is a precision instrument. Handle it with
CAUTION
care and avoid subjecting it to a sudden or severe impact.
· When the microscope is to be reinstalled or transported, be
sure to secure the moving parts with the provided clamping
devices and use the boxes in which the microscope was
packed when you purchased it.
· Never disassemble any part of the product. Otherwise,
failure could be caused.
· Do not use the system in areas where it may be subjected
to direct sunlight, high temperature and/or humidity, dust
or vibrations.
(For the operating environmental condition such as
temperature and/or humidity, see "8 Specifications" (page
83).
Avoid using the instrument in the following places.
(1) Near an inlet or exhaust outlet of air conditioning
equipment, etc.
(2) In a place subjected to large vibrations or change in
temperature.
(3) Near equipment producing abnormal noise (including
non-Olympus equipment)
(4) In a place subjected to direct sunlight.
(5) In a place subjected to excessive dirt or high
temperature and humidity.
(6) Near flammable substance (gasoline, lacquer thinner,
alcohol, etc.)
· If you don't have any choice but to use the system in a
place where temperature fluctuates significantly or where
temperature and humidity are high, apply rust preventive
oil on unpainted parts of the stage mount for rust may
occur on that parts.
· Do not to block the air vents of the control box, the power
supply unit and microscope frame, keep a space of 10
cm or more between the right/left/back sides and the
surrounding objects.
1. Each module is very heavy. Be sure to carry it by the following
number of transport persons.
} Number of transport persons per module: 1 or more persons
(STM7-CS50, STM7-CS100); 2 or more persons (STM7-SF, STM7-SFA,
STM7-MF, STM7-MFA, STM7-CS200); 4 or more persons (STM7-LF,
STM7-LFA, STM7-CS300)
2. As a center of gravity is at the rear of the frame, the rear transport
stick is heavier. Carry it carefully.
3. Carry the frame STM7-SF/STM7-SFA/STM7-MF/STM7-MFA using the
transport sticks.
STM7
5