Olympus STM7 Instructions Manual page 67

j
c
a
8
Loosen the clamping screws of the stage transport locks j (2
positions) with the Allen wrench provided with the frame, and remove
the locks.
} In case of STM7-CS50 or STM7-CS100, the stage transport locks are
attached to the lower front area and the right side of the stage.
} In case of STM7-CS200 or STM7-CS300, the stage transport locks
are attached to the rear side and the right side of the stage.
8 9
Move the X- and Y-axes of the stage, insert the clamping screws k
provided with the stage into the mount holes on the stage base,
and clamp the screw using the Allen screwdriver provided with the
stage.
A number of clamping screws for STM7-CS50, STM7-CS100 or STM7-
CS300 is 4 pieces and 2 pieces for STM7-CS200 respectively.
CAUTION
k
10
In case of STM7-CS200 or STM7-CS300, remove the transport sticks
h (4 positions) by rotating.
In case of STM7-CS50 or STM7-CS100, remove the transport rods i (2
positions) from the stage with the Allen wrench provided with the stage.
STM7-RS100/STM7-RS200/STM7-RS300
When the rotatable stage is placed on the stage, the specimen on it
can be rotated so the parallelism can be adjusted easily.
CAUTION
1
Place the rotatable stage a gently on the center of the table b .
} Align the X/Y directions of the rotatable stage a precisely with
those of the stage b . The attaching holes and the attaching screw
holes should coincide now.
b
2
Using the Allen wrench (small) provided with the frame, firmly tighten
the 2 clamping screws c provided with the rotatable stage.
· Hold the transport sticks or transport rods when aligning
the screw positions (for malfunction may occur if any other
part of the stage is subjected to strong force).
· Be careful not to drop the clamping screws when inserting
them.
· Remove any oil, dirt and stain from the bottom surface of
the rotatable stage.
· When placing the rotatable stage, be careful not to hit the
glass on the stage.
· When carrying the rotatable stage, hold it by putting your
hand on the groove on the side surface of the base of the
rotatable stage. Do not hold any other parts.
STM7
61