Olympus STM7 Instructions Manual page 17

Control box
} Refer to the instruction manual provided with the control box.
Repair and movement of the system
1. The assembly and setup are performed by the Olympus dealer.
Do not repair or move the microscope by yourself. If you want to
move the microscope, consult an Olympus sales office. If repairing
or moving the microscope by you should cause the microscope
to malfunction or be damaged, Olympus shall not be liable for the
consequence. Even if the consequence occurs during the warranty
period, the service may have to be chargeable.
2. Do not carry the microscope without the dedicated transport tools or
packaging materials. Otherwise, the accuracy is not ensured.
• Be sure to carry the microscope carefully only by those who
understand the transportation cautions (described in the
instruction manual).
• Those who install the microscope must read the descriptions
in the instruction manual and understand the installation
procedures.
3. When transporting the STM7, be sure to use the dedicated
transporting tools and packing materials. Consult your local
Olympus representative for details.
4. When transporting, be sure to use the Z-axis transport lock and
clamps/screws. Even though the clutch of the stage is fixed, if the
stage is tilted significantly, the stage will be moved, which is very
dangerous.
5. Relocating the microscope overseas by you without notifying
Olympus in advance will not allow you to enjoy the service in the
country where the microscope was relocated.
6. If you relocate the microscope overseas, note the following matters:
• The power cords must be replaced with ones that can be
used in your destination.
• Confirm that the device is conformed to the laws and
regulations of the relocation destination.
• Some countries and regions have not established the
Olympus service system. Contact Olympus for details.
• Not all the countries and regions with the Olympus service
system provide their after-sales services under the same
conditions as those in your country.
Certificate of Accuracy
1. Do not lose Certificate of Accuracy. The setting values of factory
default values (accuracy assurance) are described in Certificate of
Accuracy.
STM7
11