Olympus STM7 Instructions Manual page 71

b
a
c
e
h
g
i
Mounting the revolving nosepiece/objectives
10
(MM6C-KMAS, MM6C-RLAS)
1
Loosen the revolving nosepiece clamping screw a on the reflected
light arm using the Allen screwdriver provided with the microscope frame.
2
Fit the mount dovetail b of the revolving nosepiece gently into the
revolving nosepiece attaching area on the reflected light arm and push
in all the way until it is stopped.
3
Tighten the revolving nosepiece clamping screw a using the Allen
screwdriver provided with the microscope frame, and mount the desired
UIS2 (UIS) objectives c by screwing in firmly.
} It is recommended to mount objectives in order from low-
magnification to high-magnification objectives. In this way, it will be
easy to change the magnification later.
d
When using the coded revolving nosepiece
} Before mounting the nosepiece, remove the reflected light arm from
e
the microscope frame. (see page 62)
1
Loosen and remove the screws e (4 pcs.) of the revolving nosepiece
mount on the reflected light arm d using the Allen screwdriver
provided with the microscope frame.
2
Turn the revolving nosepiece mount f 90 degrees.
3
Fix the revolving nosepiece mount by tightening the screws e (4
pcs.) using the Allen screwdriver.
4
After mounting the reflected light arm d on the microscope frame, fit
f
the coded revolving nose into the mount from left side.
5
Mount the desired UIS2 (UIS) objectives by screwing in firmly.
When using the measurement objective
1
Loosen the clamping screws g of the reflected light arm sufficiently
using the Allen screwdriver provided with the frame.
2
Insert the dovetails of the adapter to mount measuring objectives
STM7-MMOBAD h into the objective attaching area of the reflected
light illuminator arm from the front. And push it until it touches the end.
3
Tighten the clamping screws g of the reflected light arm securely
using the Allen screwdriver provided with the frame.
4
Screw the objective securely into the objective i attaching area.
STM7
65