Olympus STM7 Instructions Manual page 81

a
b
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
1
While pressing the X-, Y- and Z-RESET buttons a of the digital indicator
at the same time, set the main switch b of the control box STM7-CB/
STM7-CBA to " " (ON).
Keep pressing the X-, Y- and Z-RESET buttons, and wait for approx. 3 seconds.
The microscope starts in the maker setting mode.
2
Setting the X-axis counting direction
While display X shows "1", press the Y-RESET button d or the Z-RESET
c
button e to set the X-axis counting direction in the display Y.
d
} For setting values, see "2 Setting Function List" (page 79).
e
3
Inputting the standard value of X-axis
1. Press the X-RESET button c to show "2" in the display X.
c
2. Press the DATA button f to change the digit you want to edit
d
in the display Y.
e
3. Press the Y-RESET button d or the Z-RESET button e to set
f
the display Y to "Standard value" of "X-axis" described in Certificate
of Accuracy (provided with the stage).
} The unit of values in the display Y is mm.
STM7
75