Olympus STM7 Instructions Manual page 83

X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
X
Y
Z
COUNT AF FOCUS LED
Z LIMIT DATA
FULL TRACK COARSE EPI DIA FN
HALF SHOT FINE
8
Setting the Z-axis counting direction
1. Press the X-RESET button c to show "7" in the display X.
c
2. Press the Y-RESET button d or the Z-RESET button e to set
d
the Z-axis counting direction in the display Y.
e
} For setting values, see "2 Setting Function List" (page 79).
9
Inputting the standard value of Z-axis
1. Press the X-RESET button c to show "8" in the display X.
c
2. Press the DATA button f to change the digit you want to edit
d
in the display Y.
e
3. Press the Y-RESET button d or the Z-RESET button e to set
f
the display Y to "Standard value" of "Z-axis" described in Certificate
of Accuracy (provided with the frame).
10
Inputting the measured value of Z-axis
1. Press the X-RESET button c to show "9" in the display X.
c
2. Press the DATA button f to change the digit you want to edit
d
in the display Y.
e
3. Press the Y-RESET button d or the Z-RESET button e to set the
f
display Y to "Measured value" of "Z-axis" described in Certificate
of Accuracy (provided with the frame).
11
Saving setting values
1. Press the X-RESET button c to show "11" in the display X.
c
2. Press the Y-RESET button d or the Z-RESET button e to show
d
"1" in the display Y.
e
3. Press the DATA button
f
· Without this procedure, the inputted values are not saved in
CAUTION
the microscope. Be sure to execute this procedure.
· If any one of setting values
shown in display Y) is 000.0000, the setting values cannot
be saved.
Confirm the setting values again.
f .
3 4 6
, , ,
An error sound (three short beeps) beeps.
STM7
7 9 10
, or (values
77