Olympus STM7 Instructions Manual page 64

e
c
d
58
d
b
a
d
3
Loosen the screws d (2 pcs.) of the Z-axis transport lock c using
the Allen wrench provided with the frame, and remove the Z-axis
transport lock c .
When removing the screw, be careful not to drop the
CAUTION
screw inside the frame.
4
Attach the screws d to the frame again.
5
Rotate the transport sticks b (4 pcs.) to remove them from the frame.
2
Mounting the digital indicator
1
Fit the screw holes a (2 pcs.) on the right of the column with the screw
holes b of the digital indicator STM7-DI, and secure the clamping
screws b (2 pcs.) provided with the digital indicator by using the Allen
screwdriver provided with the frame.
Hold the digital indicator until it is secured on the column.
CAUTION
} If the digital indicator is attached to the microscope, store the shafts
d (2 pcs.) provided with the digital indicator on the rear of the
digital indicator.
} Rotate the rubber area of the shaft to tighten the screw of the rubber
area. Then, store the shafts.
} When using the digital indicator on the table, screw the shafts d
(2 pcs.) provided with the digital indicator into the rear cover of the
digital indicator securely.
} If the digital indicator is shaky on the table, rotate the rubber area of
the shaft to adjust the shaft length.