Olympus STM7 Instructions Manual page 85

1
Maker setting mode
Setting values in the maker setting mode must be inputted by Olympus.
Do not change the setting values by yourselves.
The work to solve the problems caused by changing the setting values are for compensation.
2
Setting Function List
Setting
Items Setting Items
Display X
1 X-axis counting direction
2 Standard value of X-axis
3 Measured value of X-axis
4 Y-axis counting direction
5 Standard value of Y-axis
6 Measured value of Y-axis
7 Z-axis counting direction
8 Standard value of Z-axis
9 Measured value of Z-axis
10 Loading setting values
11 Saving setting values
12 Exit
Setting Values
Setting Values
Display Y
0* Move the stage to left: Positive
1 Move the stage to right: Positive
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
0* Move the stage to front: Positive
1 Move the stage to back: Positive
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
0* Move the focusing unit up: Positive
1 Move the focusing unit down: Positive
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
000.0001* to Value described in Certificate of
999.9999 mm Accuracy
0
1
0
1
0
1
Do not change unless
necessary.
(It is not necessary to
set at delivery.)
Do not change unless
necessary.
(It is not necessary to
set at delivery.)
Do not change unless
necessary.
(It is not necessary to
set at delivery.)
No
Yes
No At delivery, after
Yes inputting the setting
No
values, be sure to
Yes
select [1: Save] and
exit.
STM7
Remark
* Initial value
79