Advertisement
Step 16: Roof Support Assembly
Part 1
A: Attach (180) Roof Support to (181) Roof Support Left at peak using 1 (S4) #8 x 3" Wood Screw. (fig. 16.1)
B: Place (182) Top Post Right and (183) Top Post Left on the ground with the notched out side facing up. Place
(184) SW Top over (182) and (183) Top Post Right and Left so the notches fit together. (fig. 16.2 and 16.3)
C: Place Roof Support Assembly over (184) SW Top with the counter sunk holes facing up then attach with 2
(G8) 5/16 x 2" Hex Bolts (with lock washer, flat washer and t-nut). The angled edges of (182) and (183) Top Post
Right and Left should be flush to the outside edges of (180) Roof Support and (181) Roof Support Left and the
tips of each (182) and (183) Top Post Right and Left should be flush to the top of (184) SW Top. (fig. 16.2 and
16.3)
Fig. 16.1
181
Wood Parts
1 x
Roof Support FSC 5/4 x 4 x 29"
180
1 x
Roof Support Left FSC 5/4 x 4 x 29"
181
1 x
Top Post Right FSC 1-1/4 x 2-1/8 x 24-5/8"
182
1 x
Top Post Left FSC 1-1/4 x 2-1/8 x 24-5/8"
183
1 x
SW Top FSC 1-1/4 x 5 x 36"
184
5/16" Lock Washer
5/16" Flat
Washer
183
5/16" T-Nut
Notice countersunk
hole facing up
S4
180
Flush
Hardware
1 x
#8 x 3" Wood Screw
S4
2 x
5/16 x 2" Hex Bolt
G8
(5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
51
Fig. 16.2
G8
181
180
184
182
180
184
182
183
Fig. 16.3
181
Flush
Advertisement
