Advertisement
Step 32: Attach Swing End Ground Stakes
A: In the 2 places shown in fig. 32.1 drive the Rebar Ground Stakes 13" into the ground against the boards. Be
careful not to hit the washer while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes to (272) SW Posts using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 32.1.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Warning!
ground. Digging or driving stakes can be dangerous if you do not check first for under-ground
wiring, cables or gas lines.
Fig. 32.1
272
Rebar
Ground
Stake
To prevent tipping and avoid potential injury, stakes must be driven 13" into
1 per ground
S7
stake
13" In Ground
Rebar
Ground
Stake
Hardware
2 x
#12 x 2" Pan Screw
S7
85
Other Parts
2 x Rebar Ground Stake
Advertisement
