KidKraft Grand Valley Retreat Installation And Operating Instructions Manual page 65

Step 21: Attach Roof Assemblies to Fort
Part 2
C: Make sure the Small Roof Assembly lays flat on the Gable Angle Support Assembly and it overhangs by 2".
(fig. 21.2)
D: Measure 3/4" from the edge, 5" up from the ends of both panels and 5" down from the peak on each panel,
pre-drill with a 1/8" drill bit then attach the Small Roof Assembly to the Gable Angle Support Assembly with 2 (S3)
#8 x 2-1/2" Wood Screws per side, as shown in fig. 21.2.
S3
5"
Gable Angle Support
Assembly
3/4"
5"
Hardware
4 x #8 x 2-1/2" Wood Screw
S3
65
Fig. 21.2
S3
Small Roof Assembly