Advertisement
Step 44: Attach Elbow Assemblies and TNR2 Slide
Support
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose until
further step.
A: Attach the two remaining Elbow Assemblies as instructed in Steps 42 and 43.
B: On the fourth Elbow Assembly attached remove the pan bolt and nut which is facing the fort (installed in Step
40). (fig. 44.1) The bolt will no longer be needed, but keep the lock nut.
C: Loosely attach TNR2 Slide Support (at the slightly bent end) to the Clamp Ring using 1 (PB6) 1/4 x 1" Pan
Bolt (with flat washer and the previously removed lock nut). (fig. 44.2)
D: Rotate TNR2 Slide Support and attach to (060) SL Panel using 1 (S6) #12 x 1" Pan Screw as shown in fig.
44.2.
E: Fully tighten screw and bolt.
Fig. 44.2
TNR2 Slide
060
Support
Note: Flat
end down
Remove PB1 (1/4 x 3/4"
Pan Bolt first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
Lock
Nut
Flat
Washer
PB6
S6
1 x
#12 x 1" Pan Screw
S6
1 x
1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
16 x
1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
Fig. 44.1
Hardware
100
Attach 2
remaining
Elbow
Assemblies
Other Parts
1 x TNR2 Slide Support
4 x TNR2 Slide Clamp Ring
Advertisement
