Advertisement
Step 2: Access Ladder / Rockwall Assembly
Part 2
E: Place (023) Ladder Gap on each access rail so there is a 2-3/8" gap between (023) Ladder Gap and the top
(022) Ladder Tread. Attach using 4 (S20) #8 x 1-3/8" Wood Screws. (fig. 2.4 and 2.5)
F: Place (024) Rock Rail on the ground next to (021) Right Access Rail so it matches the orientation of the two
access rails as shown in fig. 2.6. Attach (025) Top Ladder to top of Access Ladder assembly and (024) Rock
Rail using 3 (S3) #8 x 2-1/2" Wood Screws. Notice that the holes in the board are towards the top and notched
end is at (024) Rock Rail. (fig. 2.6)
G: Attach 1 Swing Bracket to the top angled edge of (024) Rock Rail, making sure the bracket faces out. Use 1
(WB2) 5/16 x 1-3/8" Wafer Bolt (with flat washer and t-nut). (fig. 2.6)
Fig. 2.4
Fig. 2.6
020
Wood Parts
1 x
Ladder Gap FSC 1 x 4 x 15"
023
1 x
Rock Rail FSC 2 x 4 x 62-7/8"
024
1 x
Top Ladder FSC 5/4 x 3 x 34-1/4"
025
021
020
021
5/16" Flat
Washer
023
3 x
S3
1 x
WB2
S20
4 x
Fig. 2.5
023
024
Swing Bracket
WB2
025
Hardware
#8 x 2-1/2" Wood Screw
5/16 x 1-3/8" Wafer Bolt
(5/16" flat washer, 5/16" t-nut)
#8 x 1-3/8 " Wood Screw
23
2-3/8" gap between top
Tread and Ladder Gap
S20
5/16" T-Nut
S3
Other Parts
1 x Swing Bracket
021
023
020
Notice holes
towards top of
board and notch
to this side.
Advertisement
