Advertisement
Step 47: Attach Exit End Assembly to Fort
Note: When installing Pan Bolts make sure to
look at holes so bolts go through the side with
the round recess and the lock nuts go through
the side with the hexagonal recess. Keep all bolts
loose until further step.
A: Fit the Exit End Assembly to the last Elbow
Assembly by lining up the arrows on each assembly.
Notice the elbow orientation. (fig. 47.1)
B: Attach 1 TNR2 Slide Clamp Ring to the top of the
joined Assemblies using 3 (PB1) 1/4 x 3/4" Pan Bolts
(with lock nut), making sure to match the arrows up
with the end of the clamp ring (where a seam will be)
as shown in fig. 47.1.
Use Quadrex Driver as a guide pin for each hole
before inserting bolt.
C: Attach 1 TNR2 Slide Clamp Ring to the bottom of
the joined Assemblies using 3 (PB1) 1/4 x 3/4" Pan
Bolts (with lock nut), making sure to match the arrows
up with the end of the clamp ring (where a seam will
be) as shown in fig. 47.2.
D: Connect the 2 TNR2 Slide Clamp Rings together
in 2 spots using 1 (PB1) 1/4 x 3/4" Pan Bolt (with lock
nut) per hole. Make sure seams and arrows line up
and then tighten all bolts. (fig. 47.3).
Fig. 47.3
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
PB1
Lock
Nut
8 x
Fig. 47.1
Top Slide Bolt Holes
Fig. 47.2
Hardware
1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
103
Elbow
PB1
Assembly
Lock
Nut
Make sure arrows
are aligned
Bottom Slide Bolt Holes
Lock
Nut
PB1
Other Parts
2 x TNR2 Slide Clamp Ring
Exit Elbow
Assembly
Advertisement
